The Luminous Word Archer With Three Rounds

Rolling round: the aluminum side of the luminous word round round, with three different diameter of the round, the effective folding height, but also with a triangular prism, can be slotted directly attached to the triangular column on the corner, corner bending arc when fixed In the table and then fold, the use of more convenient! Aluminum side flat luminous word production process: Equipment required: engraving machine, slotting machine     Now the domestic market on the aluminum side is divided into three kinds, namely, aluminum, aluminum and aluminum-plastic side, but the aluminum-plastic edge of the aluminum content of how much less to see the needs of the guests. And these three kinds of side to do the effect is not the same, the aluminum word is relatively hard, suitable for outdoor, the color is painted or paint, is the cost and selected, and aluminum than the aluminum soft, more suitable for small characters , Do some big brands of small print, looks more high-end, aluminum-plastic side than the aluminum coil is even more soft.     In fact, the aluminum side of the plane light word is very good to do, is also very simple, very easy to just start to do the word.     Step one: the panel is the acrylic, carved directly engraved with a car on it.     Step two: the edge, you can choose is a fully automatic slot machine or manual slot machine, fully automatic to a lot of convenience, do not have to mark, but you have to consider the automatic slotting function can not use alloy blade , If it is the best, can not choose the manual slot machine installed on the alloy blade to slot, opened the slot out of the effect will be very good, very straight angle is very three-dimensional.     Step three: open a good edge of the edge of the edge of the arc on the first use of archer or hand to work about the small curvature of the tools must be used to get, arc do not have to do too accurate, get a rough on it , And then set in the panel, in turn, glue, fixed methods are many kinds, some with a long nail on the wooden table with the words of the edge of the word, this method is more trouble, is more cost savings, but effort, Some get a metal table, with a strong magnetic to withstand, so more convenient, and the cycle is very strong, if it is more permanent magnetic, basically no longer need to invest.     Step 5: Adhesion of panel and edge. Because the panel is acrylic, so can not be welded, use glue, you can use glass glue or AB glue, but the glass glue to do more slowly, AB glue on the faster, 3-5 minutes on it, so The best way is to first layer of AB glue, and then AB glue above a layer of glass glue, so sticky word is very strong, if you worry about the cost can only AB glue, but the word more than 60 cm to die.     Step 6: Adhesive the word shell in the bottom of the word piercing the screws, and then put the lamp installed on the bottom plate, the good screw on it. -