Film faced plywood

Film faced plywood Moisture (8-12%) & densityproducts Weight(kg/m3) Birch About 690 Combined About 600 Poplar About 500 Conserve and maintain: How to cut the best from our film faced plywood Storage Always clean and repair the formwork panels before storage. The formwork should then be stacked off the ground on level supports and under cover. Framed formwork panels should be stacked alternately face and back to back to avoid face damages by bolts etc. If panels are wet, do not allow them to dry too rapidly. Sealing of edges Phenolic fabric film faced plywood edges are fully sealed at the factory and it is the most important that all edges remain sealed. To obtain full value from a phenolic fabric film faced sheet any recut edges should sealed as soon as possible with water proof paint. Sealing of holes Any holes made in fabric film faced formwork panels should also be sealed to prevent water entering. If water does enter it may cause swelling around the holes. Cleaning and repair To obtain full life, cleaning should be carried out immediately after each use. Phenolic fabric film faced plywood may be wiped with release agent or cleaned with water and stiffbrush . It may be necessary to use a hard wood scraper but care should be taken not to damage the plywood face. Do not use a wire brush or sharp metal scraper to dislodge hardened concrete